Mockingboard

From The ReActiveMicro Apple II Wiki
Revision as of 02:43, 29 May 2016 by RMHenry (talk | contribs)
Jump to navigation Jump to search

The Mockingboard is a sound card for the Apple II family of microcomputers built by Sweet Micro Systems. In 2005 ReActiveMicro (then called GSE-Reactive) produced a clone of the board called "Mockingboard v1". In 2015 Tom Arnold of philosophyofsound.com also produced a run of the board relabled as ""Mockingboard v1a" which Ulitmate-Micro helped distribute via the UltimateApple2.com Store.


History

The Mockingboard v1 was the first project ReActiveMicro started with in September 2005. After a bit of market research there seemed be enough demand to warrant this project. The board itself also seemed like a good candidate since it was a simple design, 2 layer PCB, and used standard parts which were still easily sourceable. Henry then found the board on eBay and won the auction.

Henry had been discussing possible project ideas with Bill Garber. Bill offered to help show Henry how to use ExpressPCB CAD software, which is what most beginner hobbyists used back in early and mid 2000's.

Henry disassembled the board and noted what all the parts were. Bill was involved with starting the CAD layout, however he wasn't able to finish, so Henry took over and completed the project. Bill also helped with updating the deign from an RCA Audio Cable to a 3.5mm Jack. He is also credited with the concept to add the 3.5mm Jack to the rear side of the IIe, which allows a more simple and shorter cable connection. Henry is credited with adding the II speaker input jack circuit to the board.

Known Errors In The v1 And v1a Designs

In 2016 Chris Torrance found that the 3.5mm Jack was wired backwards. Also the II speaker input jack circuit is of a lower lever then the Mockingboard sound effects. Chris has a few videos that can be found on YouTube concerning these issues. https://www.youtube.com/watch?v=ZJcy34_rT70 https://www.youtube.com/watch?v=Ermg5BLPfj8